微波EDA网,见证研发工程师的成长!
首页 > 研发问答 > 微波和射频技术 > 天线设计和射频技术 > what is RF amplifier?

what is RF amplifier?

时间:04-11 整理:3721RD 点击:
Hi, all,
I am a newbie in RF, and want to know what is the difference between normal opamp and RF amplifier. To construct a power amplifier after antenna, must i use an RF amplifier at 433 mhz? If yes, please recommend a few model.
Thanks.

T. Cambrige

a good place to star is this site
http://hem.passagen.se/communication/meny.html
have many RF project and if you want make a RF power
amplifier look about RF Device Data Vol. I and II from Motorola, I have it but in
paper.

https://www.edaboard.com/viewtopic.p...2&highlight=rf

useful document on introduction to Power Amplifiers attached &
Good books for PA design are
1 RF Power Amplifiers for Wireless Communications
By: Steve C. Cripps

2 Advanced Techniques in RF Power Amplifier Design
By: Steve C. Cripps


3 RF CMOS Power Amplifiers Theory, Design & Implementation
By: Hella & Ismail


4 Distortion in RF Power Amplifiers by:Joel & Timo


5 High Linearity RF Power Amplifiers Design
By: Kennington

An amplifer is an amplifier not matter what frequency. It essence
an op-amp is not difference than an RF amplifier. When you use
a single transistor it does not have a differencial input but still is
a feedback type of amplifier. What happen is: in high frequency the
capacitance between output and input creates a feedback that render
the opamp unuseful. The RF transistor correct that in some way.
Nowdays, there are opamp working up to 1Ghz but
they still very expensive compared to a single transistor(FET, etc).

Thanks for all your reply.
If not using RF amplifier, could I put a class A amplifier just after the antenna to increase the receive sensitivity? I am using a similar circuit as in the following link http://www.zen22142.zen.co.uk/Circuits/rf/uhfpreamp.htm

Thanks.

T. Cambridge

No luck.
Is TSH690 of STMicroelctronics suitable?
I would like to construct a power amplifier for a AM receiver. The building block sequence would be Antenna---->BPF--->PA--->Envelop detector--->Comparator.
Would this work?
Please help on this issue.
Thanks.

T. Cambridge

Added after 1 hours 54 minutes:

I would like to use some low current substitutes for TSH690. Anyone recommend?
I googled '40MHz to 1GHz AMPLIFIER', but not found.
Maxim, national, linear dont have either.
Seems only ST doing this, am i right?

T. Cam

Copyright © 2017-2020 微波EDA网 版权所有

网站地图

Top