About my project of patch antenna

Excuse me, can anyone help me, i'm currently having a project of designing a microwave patch antenna, including both software design and physical manufacture, but really i dont know how and where to start, so can anyone of you friends give me a guide for my project? Thanks alot.

it's not hard project, you can use HFSS to simulate ,and manufuture one by yourself, Don't forget to master some basic knowledge about patch antenna

you can refer to book compact microstrip antenna by king in link:

https://www.edaboard.com/viewtopic.p...6244&highlight
this book is very good in microstrip patch antenna

Hi,

You can start by defining your intended frequency,this is actually the center frequency , the materials that you'll use which is know as dielectric constant, the thickness of material from ground to your patch. With this defined parameter you can then find the impedance of the patch, its bandwidth and directivity and also the width and the length and impedance of quarter wavelength section of the microstrip trans line to match to your source and the width and the length of your patch.


Goodluck...

Hi
Check the File in following post.
U can get enough of information.
https://www.edaboard.com/viewtopic.php?p=816423#816423
I hope this will help you.
Abhishekabs

Thanks alot everyone, i will give report to u all if some (+) result come to me ....