how to design a FR4 PCB in the layout of a rectifier circuit in ads

Hello,

How can i design a FR4 PCB and simulate the S parameters corresponding to the layout of my rectifier circuit were incoporated into the simulation in ads 2009.

Thanks :)

for a rectifier board, you do not normally need s parameters unless it is a directional coupler.
or microwave you need to choose something like GETEK or a low loss FR4 which has a slightly lower dielectric constant.

If you have no board layout software, EAGLE is free.

Dear,

many thanks for your response :)

For board layout software, i used ADS 2009. for may application, I convert RF signal to DC signal using rectifier.
After that, I have to design the layout, but i have no idea, how can design it with ADS.

Have online support https://edasupportweb.soco.agilent.c..._schema=PORTAL

Hello, I design my rectifier in layout circuit using ADS, but the S-Parameter simulation does not work :/
Help please!