scaler仿真时出现的错误
时间：10-02
整理：3721RD
点击：
Memory Collision Error on RAMB16BWER : test_bench_top.mycount.u1.blk00000001.blk00000002.blk00000e05.chk_for_col_msg at simulation time 605.458 ns.
# A read was performed on address 000Z (hex) of port B while a write was requested to the same address on port A. The write will be successful however the read value on port B is unknown until the next CLKB cycle.
这是我用modelsim仿真ise的scaler IP核是产生的错误，有哪位大虾帮忙看一下啊，谢谢啊
# A read was performed on address 000Z (hex) of port B while a write was requested to the same address on port A. The write will be successful however the read value on port B is unknown until the next CLKB cycle.
这是我用modelsim仿真ise的scaler IP核是产生的错误，有哪位大虾帮忙看一下啊，谢谢啊
这个就是双端口RAM一个端口读，一个端口写，导致读和写操作同一个地址。提示是告诉你，写操作能够成功，读操作不能成功。
一般来说这种都是warning，不会导致仿真出现Error而停止。
结果是能出来的，但是发现仿真的图像是错误的，这个错误就是不能读数据，只能写数据吧。应该怎么来改正呢?
我想问一下，这个问题最终解决了吗?我也出现同样的问题
混分来了。顺便看看