How to Extract the RLC Parameters of DRO?!
时间：04-12
整理：3721RD
点击：
Hi All:
Recently I am designing a DRO. I want to simulate it in ADS. But I didn't know how to put the DR in the ADS schematic.
In some papers, a RLC equivalent circuit is put in the schematic. but how to get this circuit is a problem.So it will be good if someone can give me some information!
Thanks! :)
Recently I am designing a DRO. I want to simulate it in ADS. But I didn't know how to put the DR in the ADS schematic.
In some papers, a RLC equivalent circuit is put in the schematic. but how to get this circuit is a problem.So it will be good if someone can give me some information!
Thanks! :)
Hi!
let me first assume you are doing series feedback DRO?
To start off, download this neat program called "CARD" from www.trans-techinc.com/
It gives the conversion depending on the coupling coefficient to the ML.
You can also look up the DR book by Kajfez and Guillon, the formulas should be in there.
Thank you, gecky!
I am designing the series feedback DRO,and I am a newbie.Could you mail your DRO's ADS projects to me,I think it can give me lots of help.Thank you again!
Hi dop-radar :)
I'm a newbie too, you should refer to my other posts on Harmonic Balance and DRO design. The schematics should be there too.
This will help you
http://www.plextek.com/papers/ltcc.pdf
- What is RLC equivalent circuit of cavity resonator, Series or parallel RLC?
- How to extract RLC circuit from s-parameter touchstone file in ADS?
- RLC Extraction from S-parameter Analysis
- Extracting S parameters from RLCG values
- Parallel RLC equivalent circuit for Microstrip Antenna
- Tunnel diode oscillator with series RLC