Determining values of Max2608 VCO

hi,
i have a vco MAX2608, i cannot find a Ko in the datasheet, how do i determine it.

and another question is about the PLL, it's a LMX2326.

from my vco the tune goes to the cpo of the PLL, i need to put capacity in series to a resitor and this is parallel to a capacitor, how do i get the values for that. is there a formula?

my desired frequency is 433MHz.

after my vco i have an ETC1-1-13 because i'm working on microstripe lines and this one is follwed by a RFIC Amplifier ABA32563, but i got told that dBm value is to low. who can tell me about a better amplifier. important low cost!

i heard there a vco that allready include a amplifier but a just found very expensive ones for example modco SP 629MMs, but it is very expensive.
do you know an alternative?

thanks for help

For PLL design you should look at the ebook that is posted on national.com/wireless site, the author is Dean Banerjee, it is also available from Amazon too.

Once you have designed your circuit you can tweek it on the bench.

the link was pretty good, but they asking me about channel spacing and cyrstal frequency. i used the given values, but how do i get my desired ones. i don't know how i calculate these with my given frequeny.

i have a frequency range of 300-500MHz (VCO)

i use the max2608 is it right that PoutMin is 0.48MHz/V? what is the input cap, i haven't found a value?

i'm really a newbie,please help

bibijons