Filter Solutions Software

I designed a BPF using FilterSolutions in TX LINE mode.(Using Transmission line)

I get the schematic of filter but I do not know how to convert this sch to PCB traces.

Is there any example that shows how convert this sch to a pcb design?

There is no info on PCB shapes.

The filter cannot be made. The transmission lines of a few ohms impedance and of several hundred ohm impedance are out of the range of impedances that can be made.

who I can design microstrip bandpass filter ?(2GHZ)

Is there any info on internet about this subject?

Give your desired performance here and someone should be able to give you a design.

Please do not give me a fish!
I like to know fishing

Anyway my spec. is here:

BPF center freq. at 2GHZ with 400MHZ 3db bandwitdh.I like to design it on FR4 pcb with microstrip.
I need a good reference on how to design BPF with microstrips.

Hello,


Here you go your filter design using AWR Microwave Office (attached)
Filter Request Summery:
Implimentation: Microstrip
Shape: Butterworth
Type: Band Pass
Order: 5
Centre Freq.:2.00 GHz
Pass Band Attenuation: 3 dB
Pass Band Width: 400 MHz
Conductor Thickness: 0.018 mm
Dielectric Height: 0.7874 mm(31 mil)
Dielectric Loss Tangent: 0.014
Dielectric Constant: 4.3
Frequency Where Aliasing Begins: 6 GHz
Source Resistance: 50 Ohm
Load Resistance: 50 Ohm


---manju---

thank you;

I have AWR ver6.51 and I can not above project in it ,because it is newer version,please if possible send the v6.51 files.

Hello,


Attached BPF MWO project file works in ver. 651



---manju---