Cannot change variable valuewhile creating reports
时间：03-31
整理：3721RD
点击：
I am using HFSS 12 which is almost same as HFSS 10 or 11.
In optimetrics I chose a variable C1 to range from 0 to 200 at the linear step of 50.
After simulating, to create a report I selected C1 (instead of frequency), but it is not giving the range of values of C1. It is showing only the defining value (nominal value) of C1, which was set to zero when I created it as a project variable.
The same problem happened if C1 is created as Design properties.
Any help will be appreciated. I need a report which has X-axis as C1 ranging from 0 to 200 with steps of 50. But in report it shows only zero for C1. If the defining value or the nominal value or the starting value is set to 100. In report it shows only 100 for C1. Any suggestion would be immensely appreciated.
I have attached the file
In optimetrics I chose a variable C1 to range from 0 to 200 at the linear step of 50.
After simulating, to create a report I selected C1 (instead of frequency), but it is not giving the range of values of C1. It is showing only the defining value (nominal value) of C1, which was set to zero when I created it as a project variable.
The same problem happened if C1 is created as Design properties.
Any help will be appreciated. I need a report which has X-axis as C1 ranging from 0 to 200 with steps of 50. But in report it shows only zero for C1. If the defining value or the nominal value or the starting value is set to 100. In report it shows only 100 for C1. Any suggestion would be immensely appreciated.
I have attached the file