spb16.5里怎么出矩形焊盘钻孔

请教一下，出钻孔文件时怎么出矩形焊盘的文件?我这里出不来，出了一些警告：
Processing route path data ...
WARNING: No route path data was found for processing.
-------------------------------------------------------------
Processing slot hole data ...
WARNING: Can't find NC Route bit file (ncroutebits.txt)！
          Using T01 to route ALL route cuts.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
          Defaulting to T01 as toolname.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
          Defaulting to T01 as toolname.
WARNING: No toolcode of a size smaller than 39.37 found for a RECTANGLE slot！
          Defaulting to T01 as toolname.
OVAL      slots routed: 0
RECTANGLE slots routed: 3

搜索了一下论坛，搞定了
建立个ncroutebits.txt文件，里面填上0.01 T01
导入到cam350时，对rou文件要在导入时设置一下，和钻孔时使用的参数一致就可以了。

恭喜！

嗯，谢谢