Help me create in-ports for power combiner simulation in HFSS

I have a project for a power combiner and I'd like to simulate it in HFSS, but the inner at the in-port isn't in the port ( it's only a connector).

I try to put one 50ohms inner conected, but the results isn't so good.

'm sending a image of the 3d model of this combiner.

the out-port is in Z-axis and de in-ports is in the x-axis.

bus I dont know to create the in-ports, because the square connector is internal (it haves a conector to the EIA 6 1/8'' 50ohms)

Please, somebody help me!

help me

Have you tried to use lumped ports?

I tried it, but the resulted was bad

and it's for high-power, and I read that lumped ports is used to MS..

someone?

Hi,

With my little experience on HFSS, I think you can make a simulation with a deembed. You to continu the square connector to the external like olong z axis an thenmake your port and with a deembed.

Good luck,

PAF

Hi tadeupasetto
There are lot of HFSS tutorials posted in this forum
You will definitely find the solution by reading the tutorials.
May be, I think you have not defined the port correctly.
Also I would recommand that place the same topic in this forum part
https://www.edaboard.com/forum65.html

there are lot of experts on HFSS browsing that part.
Best of luck
ABhishekabs