AWR Microwave Office problem with adding a load pull measurements

I have a problem with the use of the load pull, when I want to add a measurement, the following error occurs:
"Project contains no valid load pull measurements"
I upload the project in case you want to see



Thx!

Hello wakuhuaco,

Yes, you need to have couple of valid measurements to do Loadpull Simulations in MWO...Go through the examples on Loadpull simulations...
Atleast any one of the measurement is required before running the Loadpull Wizard on rectnagular or tabular graph plot...
Total Power: PT
Power Gain at Fundamental: PGain
Power Added Efficiency: PAE

I have modified your MWO project file & it is now running fine...


---manju---

Thx manju :D