Pls help on LO to RF isolation for mixer in ADS ............

Dear all,

How can we draw in ADS the RF to IF, LO to IF and LO to RF isolation (loss) ? is it
S12, S13 and S 23 ? i mean that, how can i configurate the HB in ADS ?

what about conversion loss vs RF frequency ?

Thanks a lot,

Could you try placing the S parameter simulation block, then place a 50ohm terminator at the RF and LO ports, hence measure S21

Thank you but i mean that is S21 and S12 means RF to LO isolation (loss)?

Note that: port 1 : RF and Port 2 : LO

thanks in advance