how to transfer this spec?
时间：04-07
整理：3721RD
点击：
Hi, I am reading the datasheet of NRF2401 and I am planning the RF PLL block.
However, I don't know how to transfer the system spec to RF PLL requirement.
The phase noise is limited by which standard or perfomance requirement?
In the RX mode and TX mode the RF PLL works at a frequency range between 2~2.25G and 2.35G ~ 2.65G respectively.
anybody could tell me?
Thanks in advance.
However, I don't know how to transfer the system spec to RF PLL requirement.
The phase noise is limited by which standard or perfomance requirement?
In the RX mode and TX mode the RF PLL works at a frequency range between 2~2.25G and 2.35G ~ 2.65G respectively.
anybody could tell me?
Thanks in advance.
sorry if you dont mind .can i ask you a favoer ? whats rf pll block ?