how to set boundary condition of dielectric resonator filter?
时间：04-05
整理：3721RD
点击：
Hello,
I designed the 38 GHz dielectric resonator filter using CST microwave studio.
Now I have problem to set the boundary condition of dielectric resonator filter during simulation.
How to the set boundary condition? is it to set Et=0 or Open?
As attached is the designed of 38 GHz dielectric resonator filter and result with boundary condition set to Et=0.
upon fabrication of the design from CST, I measured them using Network Analyzer and the S-parameter results
is not the same with the S-parameter result from the CST. I meant the value such as S21 in CST= -1.63 dB but
in Network Analyzer is -20.215dB.
Thank you.:
I designed the 38 GHz dielectric resonator filter using CST microwave studio.
Now I have problem to set the boundary condition of dielectric resonator filter during simulation.
How to the set boundary condition? is it to set Et=0 or Open?
As attached is the designed of 38 GHz dielectric resonator filter and result with boundary condition set to Et=0.
upon fabrication of the design from CST, I measured them using Network Analyzer and the S-parameter results
is not the same with the S-parameter result from the CST. I meant the value such as S21 in CST= -1.63 dB but
in Network Analyzer is -20.215dB.
Thank you.:
condition boundary dielectric 相关文章：
- Reflection Coefficient for unmatched condition
- Importance of Unconditional Stability in LNA design.
- Meeting oscillation conditions at input or output port gives different matching?
- CST periodic boundary conditions
- bias condition for linearizer
- CST Background and Boundary Conditions for IC Chip Radiation Sims