Configuring a Bluetooth module like BlueLink

How can I configure a bluetooth module like Bluelink to work with hyperterminal ?, i attached the settings doc for it, anyone having experience with this module ?

Its user manual says, no need for any configuration to communicate with hyperterminal,
I can pair it with PC using dongle,
But cant send the data ......

Please see following link for Bluetooth Module Interfacing to BluCOM

http://www.robota.in/ftp/BluCOM-18.pdf

I figure out already, it needs no config, it was my fault

Hi,

Im looking for help, im using a btm180 to interface with a microcontroller. i want to use the at commands in Hterm but when i do i am getting no ok response, any ideas as to why this is?

if you want to interface as an UART, then program your uC and just connect it,
first do loop back test to find, if its working of not
care about rx and tx