how to fabricate the aperture coupled microstrip antenna
时间：04-05
整理：3721RD
点击：
hello
i want to know that how to fabricate the aperture coupled antenna.
as i know in aperture coupling, the ground plane is separated by two substrate or we can say ground plane is use to be situated between two substrate.
so for fabrication process if we use single side FR4 sheet if we want to fabricate using Fr4, one side of the sheet act as ground plane so lower part will be substrate then ground plane but then what we will put above the ground plane.?
i hope you got my question.
regards
i want to know that how to fabricate the aperture coupled antenna.
as i know in aperture coupling, the ground plane is separated by two substrate or we can say ground plane is use to be situated between two substrate.
so for fabrication process if we use single side FR4 sheet if we want to fabricate using Fr4, one side of the sheet act as ground plane so lower part will be substrate then ground plane but then what we will put above the ground plane.?
i hope you got my question.
regards
can anyone please help me where to get the FR4 sheet? its very urgent
from which city are you?
Visakhapatnam...
Please help me ..its very important
coupled fabricate antenna 相关文章：
- design and simulation of cross-coupled VCO using keysight ADS
- [moved] Fully Cross-Coupled Rectifier Configuration in Terms of Transistor Terminals
- Microstrip coupled lines
- Infineon BGT24MTR11 mmic: should RF in/outs be decoupled from ground?
- Coupled line filter design
- Unwanted DC voltage induced on a varactor coupled to DR? (dielectric resonator 10GHz)