Lumped Excitation and LCRs with symmetry plans
时间：04-01
整理：3721RD
点击：
Hi,
If I have a strcture with a magnetic symmetry plane and I have a lumped port and a lumped C in this plane, do I have to adjust the values for the impedance of the port and the capacity in order to get the correct results for the full strcture?
MWS does this automaticaly, but I'm not sure about HFSS
Thx,
F.
If I have a strcture with a magnetic symmetry plane and I have a lumped port and a lumped C in this plane, do I have to adjust the values for the impedance of the port and the capacity in order to get the correct results for the full strcture?
MWS does this automaticaly, but I'm not sure about HFSS
Thx,
F.
Excitation Lumped LCRs 相关文章：
- Excitation of substrate integrated waveguide with taper
- How can I set the plane wave excitation for theta=90 degree, phi=0~180 degrees
- TE mode excitation for circular patch antenna fed with coax-cable
- Waveport excitation and mode alignment
- Microstrip Port Excitation
- Excitation for LPDA (2 booms) using HFSS