Mesh in HFSS
时间：03-31
整理：3721RD
点击：
Hi all,
I am using HFSS 11.1. In HFSS, it is possible to select a particular object and assign mesh operation, for example to limit number of mesh.
Before we actually run the simulation, it is also possible to do "apply mesh operation" to see the initial mesh. However, this initial mesh generation does not depend on the mesh operation assignment set earlier. I tried to change the maximum number of mesh, however, it did not change the initial mesh.
Can anyone please confirm this?
regards,
wlcsp
I am using HFSS 11.1. In HFSS, it is possible to select a particular object and assign mesh operation, for example to limit number of mesh.
Before we actually run the simulation, it is also possible to do "apply mesh operation" to see the initial mesh. However, this initial mesh generation does not depend on the mesh operation assignment set earlier. I tried to change the maximum number of mesh, however, it did not change the initial mesh.
Can anyone please confirm this?
regards,
wlcsp
Its possible, please upload ur model
It is a company restricted design, can't share it.
wlcsp
I've had problems where I change a setting and HFSS does not realize that it now needs to rerun the simulation. Try closing HFSS, deleting the .hfssresults folder, and running the simulation again. Now the mesh operation should be taken into account.