spiral antenna design parameters need help
can any body help me in taking dimension of spiral antenna?i want to design spiral antenna for band 500ghz-800ghz.now question is that how to take its dimension should i take outer radius by lemba(min)/4 and inner by lemba(max)/4?am i right by taking it?then how to take value of phi?
phi=1/a*ln(1/lembda) is ok for this.and whould it give me value of phi at end [oint?plz tell me some formula for impedance measyre ment?plzzzzz help me
http://www.antenna-theory.com/antenn...ing/spiral.php
http://scholar.lib.vt.edu/theses/ava...ll_etd_Ch2.pdf
have a look .. this might help!
thanks a lot fot thislink. now i have a different problem in making it on hfss,when i draw one arm of spiral and try to connect it with a rectangle at its starting points i dont get unite option in boolian tab how can i draw it?
500 GHz to 800 GHz is going to result in a very small spiral. It will be difficult to fabricate for sure. You might think about your effort further to convince yourself that it is practical.
Johnson, the third edition of Antenna Handbook, has a useful discussion of spiral antennas.
hi,
thanks for your reply actually i want to design in for thz band so thinking of this frequency ,i am getting a problem with hfss design too can u plz help me in sought out that problem i formed the model and when i check validation i got msg that unit of dimension or frequency of antenna may be wrong and hence large mesh will be required also it does not do solve model and just stuck at lembda refinement how can i remove this problem
The size of the model is governed by both the physical dimensions and the wavelength in question. At these frequencies you may have an antenna that is physically small but electorally large. This can result in a huge simulation where the only solution is an equally large commuter with volumes of RAM and long solution times. The software warning is probably reflecting this and not necessarily due to a setup error.