Probe Fed Patch Antenna : S-Parameters improvement using HFSS. HELP needed
antenna snaps are attached with it.
you can say the basic parameter to design in HFSS for me?
I can simulate it for you and say the results.
but I don not have any idea about your problem. are you professional in working with HFSS?
HR Karami
sir , i am student of engineering .
and the design parameter(hfss) for my probe feed patch antenna are
f=2.85ghz
substrate=(FR4) with height=.15cm
Air(Vaccume) box between substrate and ground plane with height=.5cm
probe material=PEC with diameter =.127cm
coax meterial=teflon with diameter=.41cm
if you want me to attach my hfss file kindly let me know please..
THANKS ...
- - - Updated - - -
this is what i get at the ouput when i run my hfss antenna ..you can see that its s-parameter is not good ...kindly let me know how to improve it please..
I did not access to the HFSS on my system and I had to simulate and design a new antenna for you. you did not give me complete information for simulation. for example what is the location feed?
however to help you I simulate a patch antenna with probe feed and the other properties as follows,
L = 46.8
W = 33.2
h = 2.87
er = 2.2
wire radius using in feed = 0.65
GND_L = 80
GND_W = 50
all boundaries set to open add space
delta s = 0.01
the scattering parameter is attached to this reply.
HR Karami
dear sir!
thanks so much for your simulation for meee. my requirements are as mentioned above caz have to practically implement it ..
thanks alot but if i can get ur ID so that i could mail you my HFSS file i wud be very greatful if you culd help mee wid that caz ive to design antenna for
F=2.85Ghz.
- - - Updated - - -
dear sir!
thanks so much for your simulation for meee. my requirements are as mentioned above caz have to practically implement it ..
thanks alot but if i can get ur ID so that i could mail you my HFSS file i wud be very greatful if you culd help mee wid that caz ive to design antenna for
F=2.85Ghz.
Hai every one
i am an engineering student i want to design a l probe feed patch antenna can any one help me
plzzzzzzzz..thanks in advance
To start you can read this file.
I think this is very good for starting.
I'd advise you to check out this post as well, this is where I got my help :) good luck!
https://www.edaboard.com/thread166237.html