微波EDA网,见证研发工程师的成长!
首页 > 研发问答 > 微波和射频技术 > 电磁仿真讨论 > 4G antenna specifications

4G antenna specifications

时间:03-30 整理:3721RD 点击:
Hi friends
I'm going to design an MIMO antenna for cellphone that is suitable for 4G cellular systems. But I have some vague that I looked for a lot and found nothing. Would you please give me a clue for following issues:
1. What is the frequency and frequency range for UL and DL in LTE-Advanced (4G). I found that the spectrum flexibility for LTE release 10 are:
? 450?470 MHz band
? 698?862 MHz band
? 790?862 MHz band
? 2.3?2.4 GHz band
? 3.4?4.2 GHz band
? 4.4?4.99 GHz band
So what does that mean? Should we design an antenna in one of the aferomentioned frequency ranges or it should cover all ?

2. How much is the required bandwidth for LTE-Advanced in designing the antenna. As I found the minimum is 40 MHz and the maximum limit is 100 MHz. But some articles mentioned this bandwidth will provide by Carrier Aggregation of 2 up to 5, 20 MHz contiguous spectrum. So how much bandwidth should we consider in our design? 20 MHz (same before?) or 40 MHz ?
3. As some articles mentioned it required at most 8

8 MIMO. Locating 8 antennas on cellphone is impossible. I need to know that is it possible to locate 2 antennas on cellphone and support the required bit rate in 4G or we need at least 4 antennas?

So appreciated.

Well not a very technical guy I am but I am using LTE technology in mobile. Long Term Evolution (LTE) is new revolutionary concept in mobile internet.
I think it should cover all because different service providers uses different frequencies to provide services of 4G like AT&T uses 700 Band 17, 1700/2100 MHz, Verizon uses 700, 1700/2100 MHz etc.

上一篇:3d FDTD code using MUR ABC
下一篇:最后一页

Copyright © 2017-2020 微波EDA网 版权所有

网站地图

Top