sdr programs if 12khz
Yes
the LO cam be defined at 4* 455KHz to get the IQ clocks
the IF signal may be picked up before the internal filter, amplified and separate filtering adopted as per your needs
sir can u suggest some radio IC for the purpose, like if u have tried some. actually m a bit reluctant because i m afraid of the reason tht my input signal can burn the data conversion module if it som how exceeds the max voltage .... Sir if u dont mind can u eloborate a bit bout IQ clocks...
Added after 9 minutes:
and secondly you said "LO can be defined at..." ... sir as per my knowledge ,i read on one of the radio IC's config pin ( FM IF out) ,i was planing to solder a wire from that pin (assembled FM radio kit) and connect an SMA connector and input in data conversion module ....what u suggest?
SMA connector may not be needed. Normal BNC RF connector with 75 ohms impedance would do.
The site below has many suggestions, where to pickup the 455KHz signal for various types of receivers.
http://www.drmrx.org/receiver_mods.html
Perhaps this one suggests to convert it to 12KHz by using another mixer with LO at IF+12KHz, and Dream software can convert the DRM signal back to CD quality audio.
It would be useful to you only to suggest the pick up point and its handling. Later this signal becomes an input to your SDR.
if you feel the signal is High, you can put a preset pot and adjust to a suitable level.
The working voltage of Receiver, may not have much to spoil your SDR, i feel.
Sarma