microwave office

Hey all,

I am trying to run MWO to optimize some parameters and I was hoping someone might have a tutorial on this to help me do it correctly and alot faster than I have in the past?

I want to optimize Sparameters and VSWR.

Thanks for your help ahead of time!

~Nick

Hello,

Yes, go through the Getting Started Optimization section, which shows step by step procedure...
http://www.elec.mq.edu.au/cnerf/reso...ingStarted.pdf
www.gigacomp.ch/pdfs/Tutorial.pdf
http://www.awr.tv/

It is simple after simulation
1. select the element parameters you want to optimize (if needed constrain limits)
2. Add the VSWR & S-parameter optimizer goals
3. Then go to Simulate => Optimize (leave the deaulft optimizer method & iterations).
4. now you should be able to see the optimized design...!

Or upload your MWO project file (*.emp), & VSWR Goals ...I will suggest I how to setup...


---manju---