Re: Help! perform parameter sweep in transient simulation in

Hi,

I designed a microstrip coupler in the Agilent ADS environment and ran transient simulation to observe the waveform of the coupled noise. My input source is VtPulse.

Now, I'm trying to sweep one of the parameters of the microstrip coupler MCLIN (e.g. the spacing S) and see the change in the coupled noise. Is it possible to do such sweep under the Transient simulation environment? I searched tutorials online, but it was mostly for DC sweep, which is not quite relevant. I followed the steps introduced in these tutorials, but the sweep controller in my case said the "analysis was not found". What should I do?

Thank you for your help!

Added after 45 minutes:

Ok, I have figured that out. :D