Monte Carlo analysis for lumped RF filter

I'm designing a lumped RF BP filter. ADS can synthesis the circuit easily with ideal LCs. Then I wnat to see the yield with different components tolerance in Monte Carlo analysis.

Question is, How can I setup ADS to directly calculate result of BP f0, so I can set f0 as a yield goal in Monte Carlo? I know ADS can do it the indirectly in dataset but I don't know how to loop this result back into the circuit window.

I hope you could understand the question. Thanks.

Use "MeasEqn(Measurement Equations Component)".

See followings.
http://edocs.soco.agilent.com/displa...ter+freq%28%29
http://edocs.soco.agilent.com/displa...+Design+System

Thanks so much. Very helpful.

In filter synthesis block, there is a "sensitivity analysis" tab, if use this tab, ads will give you the sensivity or in otherwords the statistical filter response causing by component variations.