power incident is much larger after hfss simulation
时间：03-30
整理：3721RD
点击：
under edit sources, the input power is set at 2W, after impedance matching the excitation ports, the incident power shoots to 30W! What am I doing wrong?
Usually the incident power goes up by few milli-watts after impedance matching but not a whole lot, is this acceptable? If I take absolute value of impedance, then it's usually right on.
Usually the incident power goes up by few milli-watts after impedance matching but not a whole lot, is this acceptable? If I take absolute value of impedance, then it's usually right on.
- E field in the Sphere along z-axis from incident plane calculation by mie absorption
- incident power filtering
- HFSS Waveports vs Incident Plane Wave
- *Incident Wave (Magnitute: Gaussian Beam, Phase: Plane Wave)
- HFSS - How to simulate an incident wave into a wall
- HFSS Incident Plane Wave and source scaling factor