HFSS error
时间：03-27
整理：3721RD
点击：
Hello,
I am getting a mesh error for a project I'm working on.
Mesh generation has failed. Specific details may be found in Modeler>Model Analysis>Show Analysis Dialog>Last Simulation Mesh.
The design is a vacum box with these dimentions,8um,8um,18um.
I have a smell strip of AL inside of it with these dimensions, 8um,1um,1nm.
I have set master/slave boundray conditions and I have incident plane wave on top of the box.
I want to the e field on the whole box. I get that mesh error everytime I try to run the simulation. If I change the strips Z dimendions to um, the simulation runs fine.
Any help is apprecieated.
I am getting a mesh error for a project I'm working on.
Mesh generation has failed. Specific details may be found in Modeler>Model Analysis>Show Analysis Dialog>Last Simulation Mesh.
The design is a vacum box with these dimentions,8um,8um,18um.
I have a smell strip of AL inside of it with these dimensions, 8um,1um,1nm.
I have set master/slave boundray conditions and I have incident plane wave on top of the box.
I want to the e field on the whole box. I get that mesh error everytime I try to run the simulation. If I change the strips Z dimendions to um, the simulation runs fine.
Any help is apprecieated.
Make a new project.
Got to "3D Modeler" -> "Units...".
Set the model units to "um".
Anyway, 1nm is very thin. This is less than 10 Atoms, I guess. Way below skindepth. Are you sure that your simulation makes any sense?