C/S/T M/W/S error message

Hi,

Lately I encountered an error message by the solver in C/S/T M/W/S, that the port is all covered with metal. What does it mean? It appeared when I added a port to the end of round coaxial line (inner and outer conductors, dielectric between them). I have defined the port by choosing the face of dielectic at the end of the coax line.

Thanks in advance,
Redi.

Hi!

Check your background material settings. You need to have there normal in most cases - see help...

Rgz,
eirp

Hi,

Background material was set to normal, and that is why it was so strange to me that it shows that message. When I took off the outer conductor from cable the program didn't show any messages, but the results were very inacurate, of course. What is the coaxial cable without outer conductor... :)

Greets,
Redi.

Hi,

Background material was set to normal, and that is why it was so strange to me that it shows that message. When I took off the outer conductor from cable the program didn't show any messages, but the results were very inacurate, of course. What is the coaxial cable without outer conductor... :)

Greets,
Redi.