hfss finite ground plane
Can you help me to define a port ?
The ground lines are very narrow in my model , so the port outline can't intersect side grounds. This is contrary to the tutrial.
How should I define a port? Please help me.
Without knowing the details of your problem it is hard to give specific recommendations.
On-line help under "impedance calculations" has useful suggestions. CPW lines are mode rich to that can add confusion. About the port size, why not just make the port bigger?
I prefer to use modal solutions and examine the port fields (display port fields) to see if the excitation is as I anticipated.
use a waveport
Because your ground size is small, you can use the lump port to be setten on a
plane.
Remembering to set the others 2D plane to Perfact E.
When the ground width of a CPW is very narrow, the wave port should be modified for the ground plane to touch the edge of the wave port. So, first you draw small 2D rectangles that touch both the ground plane and wave port, and then you need to substrate these rectangles from the original wave ports. Please see the attached file. The figure shows what I want to tell you.
CPW tutorial
Hello All!
Help me please! How to set port for air coplanar lines without groud? Whether it is necessary to set a layer of air as a dielectric substrate?
Thank you for your helpful replies,in particular kimx0945 and d04500 !
I have understood the meaning of 'fingers'.
good
thank you
Hi, I have some HFSS files for CPW, enjoy it.
Added after 3 minutes:
HFSS files
HFSS File
you can use waveport just like it is used in microstrip like structure simulation
malkomx
Oh, man, thnx for yours files (: