rectangle - variable - ADS2008 Layout
时间：03-24
整理：3721RD
点击：
Hello!
I′d like to simulate a rectangle (cut out in ground plane). The dimension of this cut out should be set with variables.
example: corner1(x1,y1) corner2(x2,y2).
x1,x2,y1,y2 are variables.
I know, how to define variables but I don′t know where I can use them for the rectangle.
microstrip lines can be set with w and l (variables)..and the same I need for a rectangle.
Do you understand =)
nice greetings
I′d like to simulate a rectangle (cut out in ground plane). The dimension of this cut out should be set with variables.
example: corner1(x1,y1) corner2(x2,y2).
x1,x2,y1,y2 are variables.
I know, how to define variables but I don′t know where I can use them for the rectangle.
microstrip lines can be set with w and l (variables)..and the same I need for a rectangle.
Do you understand =)
nice greetings
In ADS layout, you use variables by moving vertices. So, if you would like to increase the width of your rectangle, you grab the two corresponding vertices, and move those by the desired amount. If you current width is X, you can specify the variable to have a nominal value of X with a perturbed value of X + the amount that you move it.
First, draw your nominal rectangle. Then go to Momentum\Component\Parameters
Enter a name for your variable, the nominal value, and the perturbed value. Then click "Add".
A new layout will open up, and you grab the corresponding vertices, and move them by the perturbed value. Then click "OK", and you should be set.
Good Luck!