请教各位大大。redhawk|APL-DD mode 该如何启动

For design-specific characterization:
1. Prepare the GSR file for running RedHawk. Refer to Appendix C,“File Definitions”.
2. Select the GUI command APL -> Setup in RedHawk, or use the TCL command
setup apl -dir <dir_name>
This generates two intermediate files required for APL characterization, apache.apl
andadsLib.output, and places them in the <dir_name>/.apache directory.
In addition, four types of APL configur ation file templates are created in the
specified <dir_name> directory, to assist in preparing the proper configuration files
for characterization:
• apl.custom.config
•apl.io.config
•apl.memory.config
• apl.std.config
Cell list files for all four types ofcells are also placed in the<dir_name> directory.
3. Prepare the APL configuration file defining characterization conditions desired, as
described previously in section "APL Configuration File Description", page 9-229.
4. Run APL-DD to obtain switching current profiles, device capacitance and
resistance for cell high and low states, and leakage current for all design cells.

最后一步：RUN apl-dd ，使用apl----》character可以么?
请指教，apl-dd mode下的config与flow跟apl-di模式下的config与flow之间的差异。

你用的盗版么?

thanks