ICC write_stream gdsOut map file
Now, I am streamming out the GDS in ICC, using the gdsOut files the vendors provides. But now I think this map file is incorrect.
and here is part of the map file:
;#Avanti LayerGDSII Layer
....
A161111 1;RES_MARK
A163113 1;DIODE_MARK
A164114 1;CAP_MARK
A165115 1;BJT_MARK
A255235;prBndry
and Avanti Layers are not same with what's presented in the TF file, eg. the Layer 161,163,164,165 specified here doesn't exists in the TF file. Besides, lots of layers are missing in the map file, eg, the RES layer(111), ..... in TF files
how could I handle this,
write the map file manually, in which providing all the layers in the TF file?
thanks in advance.
normally， fab provide‘s file is correct ,
if you dont want to streamout full gds layer of whole chip , that is
streamout metal/vias only , then the gdsout map is simple ,
just contains metal/via/metal text layers, ok ,
then merge the whole gds outside icc , like icfb /calibredrv ,
thank icfbicfb,
you mean only metal/via/metal-text, those three layers is needed in the map-out file if gds-merging is needed.
thus those mark-layers is not of much significance?
thanks again.
it is formetal routing only gds , not the full level gds --------- that is , you must
merge it in icfb with other IP full gds ,
if icc layer is the same as gds, don't need mapping.
You can use "D" for data, and "T" for text, instead of "A" for all.
你要每篇文章都是学习学习， 我要发火了，