微波EDA网,见证研发工程师的成长!
首页 > 研发问答 > 移动通信 > 无线网优技术 > 3A和5G是什么意思?能不能详细说一下?

3A和5G是什么意思?能不能详细说一下?

时间:09-15 整理:3721RD 点击:
如题。

3A: 当前使用的系统的信号质量低于某个设定的门限,而其他系统的信号质量高于某个设定的门限,用于指示进行跨测量或系统切换。
5A:是质量测量事件,表示误码超过了系统设定值。

3A:当前UTRAN的强度低于某一门限,而其他系统强度高于某一门限;
 

3A事件:当前使用频率质量低于一个绝对门限,而GSM小区质量高于另一个绝对门限
5G我就只知道5代表的是质量测量,具体解释期待高人

Reporting event 5A: A predefined number of bad CRCs is exceeded 

5G我就只知道5代表的是质量测量

[1通常代表同频切换,2代表异频,3代表异系统切换,4代表Traffic测量切换等]
 
Event 1a: A Primary CPICH enters the Reporting Range (FDD only). 主公共导频信道
Event 1b: A Primary CPICH leaves the Reporting Range (FDD only). 主公共导频信道离开了测量范围
Event 1c: A Non-active Primary CPICH becomes better than an active Primary CPICH (FDD only).
Event 1d: Change of best cell (FDD only).
Event 1e: A Primary CPICH becomes better than an absolute threshold (FDD only). 绝对阈值
Event 1f: A Primary CPICH becomes worse than an absolute threshold (FDD only).
Event 1g: Change of best cell in TDD.
Event 1h: Timeslot ISCP below a certain threshold (TDD only). 干扰信号码片功率
Event 1i: Timeslot ISCP above a certain threshold (TDD only).
Event 1j: A Non-active E-DCH but active DCH Primary CPICH becomes better than an active E-DCH Primary CPICH (FDD only). 增强型专用信道(E-DCH)
 
Event 2a: Change of best frequency.
Event 2b: The estimated quality of the currently used frequency is below a certain threshold and the estimated quality of a non-used frequency is above a certain threshold.
Event 2c: The estimated quality of a non-used frequency is above a certain threshold
Event 2d: The estimated quality of the currently used frequency is below a certain threshold
Event 2e: The estimated quality of a non-used frequency is below a certain threshold
Event 2f: The estimated quality of the currently used frequency is above a certain threshold
 
 
Event 3a: The estimated quality of the currently used UTRAN frequency is below a certain threshold and the estimated quality of the other system is above a certain threshold.
Event 3b: The estimated quality of other system is below a certain threshold
Event 3c: The estimated quality of other system is above a certain threshold
Event 3d: Change of best cell in other system
 
 
event 4A: Transport Channel Traffic Volume becomes larger than an absolute threshold
event 4B: Transport Channel Traffic Volume becomes smaller than an absolute threshold
 
event 5A: A predefined number of bad CRCs is exceeded
 
 
event 6A: The UE Tx power becomes larger than an absolute threshold
event 6B: The UE Tx power becomes less than an absolute threshold
event 6C: The UE Tx power reaches its minimum value
event 6D: The UE Tx power reaches its maximum value
event 6E: The UE RSSI reaches the UE's dynamic receiver range
event 6F (FDD): The UE Rx-Tx time difference for a RL included in the active set becomes larger than an absolute threshold
event 6F (1.28 Mcps TDD): The time difference indicated by TADV becomes larger than an absolute threshold
event 6G:The UE Rx-Tx time difference for a RL included in the active set becomes less than an absolute threshold
 
 
Event 7a: The UE position changes more than an absolute threshold
Event 7b: SFN-SFN measurement changes more than an absolute threshold
Event 7c: GPS time and SFN time have drifted apart more than an absolute threshold
Event 7d: GANSS time and SFN time have drifted apart more than an absolute threshold

3A事件:当前使用频率质量低于一个绝对门限,而GSM小区质量高于另一个绝对门限。2 3G切换,RAT异系统切换。
5G就不知道了

Copyright © 2017-2020 微波EDA网 版权所有

网站地图

Top