关于设置走线宽度的宏命令问题

在ROUTER中我想录制几个走线线宽的宏设置，好比我设置数字键4 5 6对应的线宽分别为0.1MM  0.2MM  0.3MM。
我是这样录制作的，开始按F3，然后按W 设置线宽为0.2MM，
点结束，出来的宏语法为
Application.ExecuteCommand("Interactive Route", 69.6937733mm, -53.3785367mm)
Application.ExecuteCommand("Select", 68.9406267mm, -53.5396147mm)
Application.ExecuteCommand("Set Width", "0.2")
Application.ExecuteCommand("End Routing")
然后我删掉了一些无用的，最后的结束也删除了，
设置了5为快捷，但是现在按5出来的还是0.1MM的线宽，
不知道问题出在哪，

Application.ExecuteCommand("Add Route")
Application.ModelessCommand("w")DlgModelessCmd.Command = "w "
DlgModelessCmd.Command = "w 0.1mm"
DlgModelessCmd.OnOk()

Application.ExecuteCommand("Add Route")
Application.ModelessCommand("w")DlgModelessCmd.Command = "w "
DlgModelessCmd.Command = "w 0.2mm"
DlgModelessCmd.OnOk()

Application.ExecuteCommand("Add Route")
Application.ModelessCommand("w")DlgModelessCmd.Command = "w "
DlgModelessCmd.Command = "w 0.3mm"
DlgModelessCmd.OnOk()