metallic inclusion using ansoft designer
I`m using ansoft designer and i want to make a metallic inclusion inside a dielectric layer. It`s possibile ?
Yes, it's possible. Draw a dielectric, then draw a metalic, then substract metalic from the dielectric.
Could you explain me better ?
I would do in the following way:
Suppose the height of the dielectric substrate is 50 mil and you want metallic inclusions say at a height of 25 mil from the ground plane.
Create the Stackup as follows:
Signal layer 2
dielectric (25 mil)
Signal layer 1
dilectric layer (25 mil)
ground
Draw your metallic inclusions on signal layer 1.
Hope this helped.
-sv
Hi sv1437 !
When i make your stackup i think there is a problem. When i desing the Signal layer 1 and make a structure on this trace layer , let's say for example one square, what is the surrounding of this square ? I need one inclusion in a dielectric layer !
Only the square metallic inclusion will be present in the signal layer 1. First try that stackup in Ansoft Designer, I used this kind of stackup for designing two layered structures in Ansoft designer and I am pretty sure that it will work.
Let me know if it doesn't work.
-sv
I tried but i think it work not properly because the losses of my substrate are too high. I would like to subtract the layers like tony suggest, but actually i really don't know how to do it !
I don't think you can do that (subtracting layers) in Ansoft Designer. Anyways, which substrate are you using ? What is the loss tangent ?
I'm using silicon without l?ss, just to' understand what is happening. When i insert the metallic inclusions,the s parametrs become crazy.