Create SAW filter layout in ADS

Hello!

I need to create any simple layout of SAW filter in ADS and simulate it...test example.
I have not found useful information about it in the internet. ADS is not good for this case?
Can you help me may be with example, may be with first steps.
I have worked with Ka-band, so I am novice in SAW. But certainly I know theory.

Thank you!))

Hi,
SAW filter is for : Surface Accoustics Waves. I think that you can't create a layout of this type of filter in ADS except a simulation of the schematic that modelize this filter.
SAW filters have a special substrate where accoustic wave travel. The transducers assume the conversion between electric HF signal and accoustic vibration signal.
In ADS you can not simulate accoustic signal and cannot realize a layout for accoustic wave.
I you succeed in realize this filter on ADS , i am also interested ...

At first, thank you for reply)
Of course I can simulate schematic, but I need to show layout simulation. I have asked this question on forum, because I dont know how realize this substrate or is it possible realize it. If it is not possible I have to explain it. Can I do it with the other software?