微波EDA网,见证研发工程师的成长!
首页 > 研发问答 > 微波和射频技术 > 电磁仿真讨论 > Unable to increase mesh density/refinements

Unable to increase mesh density/refinements

时间:03-31 整理:3721RD 点击:
Hi,

I am a newbie to CST and I am not sure what I am doing wrong here.

I am trying to simulate a printed inverted-F antenna on a FR-4 PCB. The bottom side of the PCB is a solid ground plane except for where the antenna is. The antenna is fed using a coax with a waveguide port. I have also drawn some ground patches on the top side and have them stitched up using vias.

The structure simulates fine under default settings with a relatively large mesh line ratio limit.

For some reason, I don't seem to be able to increase the mesh density. Whenever I tried to increase lines/wavelength or increase refinement along edges or volume for any objects, the simulation either becomes unstable or all the energy are reflected back at the port (shorted). I can't use adaptive mesh generation as well because again the energy gets reflected back on the second pass.

Now I am not sure if I simulated the first pass properly.

you might want to use the local mesh properties to change the meshes.

just to check with you, are you using either open boundary or with added space to your simulation?

Regards
Wang

Copyright © 2017-2020 微波EDA网 版权所有

网站地图

Top