[HFSS] User Defined Model Simulation Error

时间：03-25 整理：3721RD 点击：

Hi, after I designed and placed my geometry .py code into the file of "UserDefinedModels" of ANSYS electronics desktop, I setup the lumped port Excitations and the analysis setup.

The design passed the validation, but when it came to the analysis process, it reported the following errors:

Code dot - [expand]
1
2
3
4
5
6
7
8
9
10
==================================================================================================
  HFSSDesign1 (DrivenModal)
    [error] Failed to refresh submodel __InductiveLink_65nm__1 (9:43:01 AM  Nov 29, 2019)
    [error] Body could not be created for part Passivation_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM  Nov 29, 2019)
    [error] Body could not be created for part ILD_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM  Nov 29, 2019)
    [error] Body could not be created for part Substrate_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM  Nov 29, 2019)
    [error] Body could not be created for part ILD_Tx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM  Nov 29, 2019)
 
..................
===================================================================================================================

Code dot - [expand]
1 2 3 4 5 6 7 8 9 10	================================================================================================== HFSSDesign1 (DrivenModal) [error] Failed to refresh submodel __InductiveLink_65nm__1 (9:43:01 AM Nov 29, 2019) [error] Body could not be created for part Passivation_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM Nov 29, 2019) [error] Body could not be created for part ILD_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM Nov 29, 2019) [error] Body could not be created for part Substrate_Rx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM Nov 29, 2019) [error] Body could not be created for part ILD_Tx because of invalid parameters of this part or some of its parent part/coordinate system. (9:43:01 AM Nov 29, 2019) .................. ===================================================================================================================

The simulation stopped at the simulation beginning,

I could not find any .pfofile/.log file to check more information about these errors.

Can anybody help me resolve this problem? Thanks!

上一篇：Simple problem with circular coil simulation on CST
下一篇：最后一页

Defined User HFSS 相关文章：

栏目分类