S-Parameter calculation by ADS

Hi mrasooli

when Ads or any other Rf software dose a simulation, it's automatically doing S parameters calculation and you can see results(S parameters) from post processing

I hope it'll be helpful

First, draw your circuit in Schematic window using lumped-component or TLines .... whatever you want. Then select Simulation-S_param from the drop-down list from left. Here you can select the "Term" component which will be your ports (connect the "term" components at the ports where you want to calculate the S-parameters, don't forget to connect the ground at - of the "term"). Select "S P" where you define your frequency range (start, stop, step etc.). Finally, run the simulation. After simulation, you can select your desired S-parameters in data display window.