Problem with CST low speed when doing a project
when i implement an example in CST, it calculatesvery fast and end simulation successfully
when i design my own project it takes a lot of more time and somethimes fails
ie : abnormally termination
i checked all the settings , and, i think, are the same of the examples(similar to my project ),what i do wrong ?
bye!!
zb
It usually happen when the mesh is not correct or port is not defined properly. its better if u upload ur project.
this is a project im working on
its very slow on calculation
the ports are well set ?
and lumpedelements?
itwas optimized in microwave office, then exported in CST by a DXF layout file
at this point another questionis : what are the settings in CST that simulate at best the settings in MWO ?
tnx for youranswer
zb
hi,
did you solve this problem or do you still need help with it?
aw
Added after 8 minutes:
hi again,
there are two things here
the ratio limit is quite high - time step is small since unecessary mesh points are used due to the cad import - try ratio limit 10
you've also set lines/wavelength = 8 - this should never be done - the wavelength sampling lower limit should always be at least 10
it seems to be fast enough (for the first mesh adaption pass.....)
good luck!
aw
Added after 1 minutes:
hi again,
there are two things here
the ratio limit is quite high - time step is small since unecessary mesh points are used due to the cad import - try ratio limit 10
you've also set lines/wavelength = 8 - this should never be done - the wavelength sampling lower limit should always be at least 10
it seems to be fast enough (for the first mesh adaption pass.....)
good luck!
aw
tnx for answer
so it can be said that the big number of meshes depended by the cad import from microwave office to CST
if i design it directly to Cst it will be more fast ?
where can i check value of timestep ?
bye, however tnx
zb
The mesh also depend upon the span of frequency u want to run the simulation.