微波EDA网,见证研发工程师的成长!
首页 > 研发问答 > 微波和射频技术 > 电磁仿真讨论 > How could I analize this filter ustrip?

How could I analize this filter ustrip?

时间:03-23 整理:3721RD 点击:
I have analized this structure with wave port using rectangles and the result is correct. Now, I want to analize the same structure with coaxial. How can I do it?

Note: I show the design with the coaxial. The result is wrong. I want to know how I can obtain a correct result.

The location of your rectangle ports are located inside the substrate, it is not possible to use waveports, everything in your model is fine, but we need change the port to lumped port, and we can still reduce the size of that rectangle to minimize the interence to whole model by this small piece of metal plane(ports are treated as the perfect E).

Anyway, this filter is just the normal planar microstrip filter escept the shape of the substrate and the ground plane, after comparing their size, I didnt get whether there is special purpose for changing the shape of the substrate and the ground plane?

If you want to use coaxial line to feed, you must use through hole via to feed the upper micrstrip, just a small size SMA connector, then you can use waveport again(the location of these waveports of coaxial line it at the boundary of your ragiation box).

PS, your attached model is not coaxial line feed.

Best Regards,

sry, I think i downloaded wrong file, this comment is for your model filter1_circular1.rar , give me more time to read your latest model. I will keep you updated.

Forgot to assign the 'Cavidad' rad boundary, just try!
Owing to poor computer, I do not simulate it.
ps: I don't know why you substracted the probe into two.

Copyright © 2017-2020 微波EDA网 版权所有

网站地图

Top