基于TJA1054设计的汽车CAN收发技术
TJA1054是控制器局部网(CAN)中的协议控制器和物理总线间的接口器件,提供差分接收和发送功能,波特速率高达125kBd,可连接高达32个节点,支持未屏蔽的总线连接,有非常低的电磁辐射(EME)和非常高的电磁干扰(EMI)免疫力,并集成了接收滤波器。
TJA1054主要特性和优势:
Optimized for in-car low-speed communication
Baud rate up to 125 kBd
Up to 32 nodes can be connected
Supports unshielded bus wires
Very low ElectroMagnetic Emission (EME) due to built-in slope control function and a
very good matching of the CANL and CANH bus outputs
Very high ElectroMagnetic Immunity (EMI) in normal and low power operating modes
Fully integrated receiver filters
Transmit Data (TxD) dominant time-out function
Bus failure management
Supports single-wire transmission modes with ground offset voltages up to 1.5 V
Automatic switching to single-wire mode in the event of bus failures, even when the CANH bus wire is short-circuited to VCC
Automatic reset to differential mode if bus failure is removed
Full wake-up capability during failure modes
Protections
Bus pins short-circuit safe to battery and to ground
Thermally protected
Bus lines protected against transients in an automotive environment
An unpowered node does not disturb the bus lines
Support for low power modes
Low current sleep mode and standby mode with wake-up via the bus lines
Power-on reset flag on the output
图1。TJA1054方框图
图2。TJA1054动态特性测试电路图
图3。TJA1054汽车瞬态性能测试电路图
图4。TJA1054应用框图
图5。TJA1054和TJA1053典型应用电路图
图6。TJA1054典型应用电路图
收发 技术 CAN 汽车 TJA1054 设计 基于 相关文章:
- 传感器网络操作系统平台TinyOS下CC2420驱动组件的设计(11-27)
- 藏在系统核心芯片中的DRAM控制器(12-10)
- 面向信号处理与通信系统的下一代设计流程(08-22)
- 为什么应该阻止静电放电?(05-28)
- 快速通往量产的四个步骤:利用基于模型的设计开发软件定义无线电(02-29)
- 一文打尽嵌入式系统设计中常用总线和接口(05-18)