门限滞回设置的C程序代码
时间:06-24
来源:互联网
点击:
将接近检测传感器集成到系统后,一个经常遇到的问题是如何正确选择接近检测的门限,以便在用户通话期间打开或关闭屏幕。门限设置须确保出现错误判断的几率非常低,而且能够支持绝大多数使用者的情况。
门限滞回例程
#define MAX44000_ADDR 0x94#define INT_STATUS_REG 0x00#define OFF_THRESHOLD 4600#define OFF_DELAY 1#define ON_THRESHOLD 4000#define ON_DELAY 3uint8 screenStatus; // 0 means off, 1 means on/*i2cWriteBytes()Arguments:uint8 address - device addressuint8 start_reg - register where the first byte is writtenuint8 *data - data to writeuint8 nbytes - number of bytes to writeConsecutively writes several bytes to some i2c device starting at some specified address -- implemented elsewhere*/void i2cWriteBytes(uint8 address,uint8 start_reg,uint8 *data,uint8 nbytes);/*MAX44000InterruptHandler()
以下代码用于实现MAX44000 INT引脚的中断处理,假设MAX44000的接近检测传感器设置为14位模式,并已使能中断。此外,假设屏幕状态初始化为1或0,详细信息请参阅数据资料的寄存器说明部分。
*/void MAX44000InterruptHandler() {uint8 i2cData[3];i2cRead1Byte(MAX44000_ADDR,INT_STATUS_REG,i2cData);if (i2cData0x01 != 0)return; // check to make sure interrupt really fired// this simultaneously clears the interrupt flagif (screenStatus) {i2cData[0] = ON_DELAY; i2cData[1] = ON_THRESHOLD >> 8 0xBF; // set ABOVE = 0i2cData[2] = ON_THRESHOLD 0xFF;} else {i2cData[0] = OFF_DELAY; i2cData[1] = OFF_THRESHOLD >> 8 | 0x40; // set ABOVE = 1i2cData[2] = OFF_THRESHOLD 0xFF;} // set the new threshold depending on what the screen status was// set the delay and threshold after each interrupti2cWriteBytes(MAX44000_ADDR,0x0A,i2cData,3);return;} // MAX44000InterruptHandler
- 嵌入式软件设计中查找缺陷的几个技巧(03-06)
- DSP HPI口与PC104总线接口的FPGA设计(04-14)
- Linux 2.4.x内核软中断机制(04-06)
- 多核DSP Bootload代码加载方法研究(06-11)
- 设计基于NXP LPC2000的次级启动加载程序用于代码升级(04-04)
- 嵌入式软件代码保护系统设计(05-08)