How do you model AM-AM and AM-PM of a PA on ADS?
I have designed a Power Amplifier and have obtained AM-AM and AM-PM plots. I would like to include the S21 parameter file (which has both am-am and am-pm) and run some simulations on the link level where I can give WCDMA signal patterns etc. Do you know how to do that? I am new to ADS so I am finding it difficult to find the solution. Any help would be greatly appreciated and would save a lot of my time.
Thanks!
Use model based on X-parameters.
https://en.wikipedia.org/wiki/X-parameters
http://edadocs.software.keysight.com...ageId=93978692
Is it also possible to have a look up table on ADS?
I would like to have an one to one mapping between the output and input. I have the look up table. How would you implement that on ADS?
Usec DAC(Data Access Component) component.
http://edadocs.software.keysight.com...ageId=82848197
Read Chapter-5 of the following book.
http://www.amazon.com/Simulation-Com...ln_b_2&s=books
The following is might be useful for your purpose, although I don't like to use.
http://edadocs.software.keysight.com...ifier)-1137212
There are two nonlinear model based on file in ADS, , although I don't like to use.
http://edadocs.software.keysight.com...iles-P2DFormat
http://edadocs.software.keysight.com...ageId=82850775
http://edadocs.software.keysight.com...ageId=82850779