ADS Co-simulation Rectifier Circuit for RF Energy Harvesting
时间：04-04
整理：3721RD
点击：
Hello everybody,
I'm making an RF energy harvesting circuit using ADS schematic and Momentum Cosimulation.
First, I simulate the circuit using schematic then convert it into momentum to obtain the layout.
After that, I bring the layout to ADS schematic to attach the lumped components, Diodes and any other elements I'm using.
The question is when I compare both schematic results and co-stimulation results, it totally shows unmatched results, means I loss any matching in the circuit. I would like to make a tuning or optimization for the layout. I made the layout based on parameters then make tuning in schematic but it always shows an error message about the parameters changing.
Once sliding the parameter, the simulation immediately exit .
Anybody have advice, what I can do?
I checked connectivity and the circuit is appropriately connected
I'm making an RF energy harvesting circuit using ADS schematic and Momentum Cosimulation.
First, I simulate the circuit using schematic then convert it into momentum to obtain the layout.
After that, I bring the layout to ADS schematic to attach the lumped components, Diodes and any other elements I'm using.
The question is when I compare both schematic results and co-stimulation results, it totally shows unmatched results, means I loss any matching in the circuit. I would like to make a tuning or optimization for the layout. I made the layout based on parameters then make tuning in schematic but it always shows an error message about the parameters changing.
Once sliding the parameter, the simulation immediately exit .
Anybody have advice, what I can do?
Schematic simulation and Momentum layout simulation result may be a slight mismatch but it should not be totally off. Check physical layout connection from the input port to output port using connectivity tool. Also, check substrate stack up. which version of ADS are you using?
I'm using ADS 2014,
Results are totally different in values, Attached is the layout and substrate stack
I checked connectivity and the circuit is appropriately connected