微波EDA网,见证研发工程师的成长!
首页 > 硬件设计 > 电源设计 > OnSemiNCV8855多输出电源控制解决方案

OnSemiNCV8855多输出电源控制解决方案

时间:07-30 来源:互联网 点击:
On Semi公司的NCV8855是集成了高边负载开关的多输出电源控制器/稳压器,能满足汽车无线系统和仪表盘电源的要求. NCV8855还集成了开关电源(SMPS)降压控制器,2.5A SMPS降压稳压器和两个低压降(LDO)线性稳压器控制器,和超低静态电流的NCV861x一起能组成8输出的无线系统或仪表盘电源解决方案.器件满足ES?XW7T?1A278?AB测试脉冲G负载条件,VIN工作电压9.0V-18.0V.本文介绍了NCV8855主要特性, 应用电路/方框图, 汽车无线电系统框图以及NCV8855评估板电路图与材料清单.

The NCV8855 is a multiple output controller / regulator IC with an integrated high?side load switch. The NCV8855 addresses automotive radio system and instrument cluster power supply requirements. In addition to the high?side load switch, the NCV8855 includes a switch?mode power supply (SMPS) buck controller, a 2.5 A SMPS buck regulator and two low dropout (LDO) linear regulator controllers. The NCV8855 in combination with the ultra?low quiescent current NCV861x IC forms an eight?output automotive radio or instrument cluster power solution. The NCV8855 has an internally set switching frequency of 170 kHz, with a SYNC pin for external frequency synchronization.

The NCV8855 is intended to supply power to various loads, such as a tuner, CD logic, audio processor and CD / tape control within a car radio. The high?side switch can be used for a CD / tape mechanism or switching an electrically?powered antenna or display unit. In an instrument cluster application, the NCV8855 can be used to power graphics display, flash memory and CAN transceivers. In addition, the high?side switch can be used to limit power to a TFT display during a battery over?voltage condition.

NCV8855主要特性:

? 1 uA Shutdown Current

? Meets ES?XW7T?1A278?AB Test Pulse G – Loaded Conditions

? VIN Operating Range 9.0 to 18.0 V

? 1 SMPS Controller with Adjustable Current Limit

? 1 SMPS Regulator with Internal 300 m NMOS Switch

? 2 LDO Controllers with Current Limit and Short Circuit Protection

? 1 High?side Load Switch with Internal 300 m NMOS FET

? Adjustable Output Voltage for All Controllers / Regulators

? 800 mV, +/-1% Reference Voltage

? System Enable Pin

? Single Enable Pin for Both LDO Controllers

? Independent Enable for High?side Load Switch

? Thermal Shutdown with Thermal Warning Indicator

? This is a Pb?Free Device

NCV8855应用:

? Automotive Radio

? Instrument Cluster, Driver Information System (DIS)

图1. NCV8855应用电路/方框图

图2. NCV8855和NCV8612汽车无线电系统框图
NCV8855评估板

图3.评估板NCV8855BMNR2GEV外形图

图4.评估板NCV8855BMNR2GEV电路图
评估板NCV8855BMNR2GEV材料清单:






详情请见:
http://www.onsemi.cn/pub_link/Collateral/EVBUM2120-D.PDF

http://www.onsemi.cn/pub_link/Collateral/NCV8855BMNR2GEVB_SCHEMATIC.PDF

Copyright © 2017-2020 微波EDA网 版权所有

网站地图

Top