CC2530 信号测试

你好，请问一下有没有什么办法可以提取SmartRF Studio里面的测试程序（Continuous TX模式）。如果批量生产CC2530模块的时候直接用这个提取的程序就可以不使用电脑就可以直接使用频谱仪测量某个信道的信号强度了，否则在电脑上面单独设置会很麻烦的。

/**************************************************************************************************
* @fn znpTestRF
*
* @brief This function initializes and checks the ZNP RF Test Mode NV items. It is designed
* to be invoked before/instead of MAC radio initialization.
*
* input parameters
*
* None.
*
* output parameters
*
* None.
*
* @return None.
*/
void znpTestRF(void)
{
uint8 rfTestParms[4] = { 0, 0, 0, 0 };

if ((SUCCESS != osal_nv_item_init(ZNP_NV_RF_TEST_PARMS, 4, rfTestParms)) ||
(SUCCESS != osal_nv_read(ZNP_NV_RF_TEST_PARMS, 0, 4, rfTestParms)) ||
(rfTestParms[0] == 0))
{
return;
}

/* Recommended settings */
MDMCTRL0 = 0x85;
RXCTRL = 0x3F;
FSCTRL = 0x55;
FSCAL1 = 0x01;
AGCCTRL1 = 0x15;
ADCTEST0 = 0x10;
ADCTEST1 = 0x0E;
ADCTEST2 = 0x03;

FRMCTRL0 = 0x43;
FRMCTRL1 = 0x00;

MAC_RADIO_RXTX_OFF();
MAC_RADIO_SET_CHANNEL(rfTestParms[1]);
MAC_RADIO_SET_TX_POWER(rfTestParms[2]);
TX_PWR_TONE_SET(rfTestParms[3]);

switch (rfTestParms[0])
{
case 1: /* Rx promiscuous mode. */
MAC_RADIO_RX_ON();
break;

case 2: /* Un-modulated Tx. */
TX_PWR_MOD__SET(1);
/* no break; */

case 3: /* Modulated Tx. */
/* Modulated is default register setting, so no special action. */

/* Now turn on Tx power for either mod or un-modulated Tx test*/
MAC_RADIO_TX_ON();
break;

default: /* Not expected. */
break;
}

/* Clear the RF test mode. */
(void)osal_memset(rfTestParms, 0, 4);
(void)osal_nv_write(ZNP_NV_RF_TEST_PARMS, 0, 4, rfTestParms);

while (1); /* Spin in RF test mode until a hard reset. */
}

你好  请问这段代码需要什么支持？或者有没有相关的调用说明  我现在简单地加入到工程里面编译出现了问题，网上又没有相关的资料可以查询