CC2640 cJTAG与XDS100V3怎么连？

CC2640 cJTAG两根线TMSC，TCKC，与XDS100V3的TMS和TCK两根线相连么？

TMSC-------TMS ----PIN1

TCKC-------TCK ----PIN11

GND---------GND ---- PIN20

PIN4必须要和GND用端接线连起来

这样连之后，CCS6运行还是识别不到器件，我把RST_N链接到PIN2，和PIN15，也不能识别，

TI的FAE大虾？这个问题怎么整？

[Start: Texas Instruments XDS100v3 USB Debug Probe_0] Execute the command: %ccs_base%/common/uscif/dbgjtag -f %boarddatafile% -rv -o -F inform,logfile=yes -S pathlength -S integrity [Result] -----[Print the board config pathname(s)]------------------------------------ C:\Users\xujuncz\AppData\Local\TEXASI~1\ CCS\ti\0\0\BrdDat\testBoard.dat -----[Print the reset-command software log-file]----------------------------- This utility has selected a 100- or 510-class product. This utility will load the adapter 'jioserdesusbv3.dll'. The library build date was 'Feb 18 2015'. The library build time was '23:56:50'. The library package version is '5.1.641.0'. The library component version is '35.34.40.0'. The controller does not use a programmable FPGA. An error occurred while hard opening the controller. -----[An error has occurred and this utility has aborted]-------------------- This error is generated by TI's USCIF driver or utilities. The value is '-180' (0xffffff4c). The title is 'SC_ERR_CTL_NO_TRG_POWER'. The explanation is: The controller has detected a target power loss. The user must turn-on or connect the power supply for the target. [End: Texas Instruments XDS100v3 USB Debug Probe_0]

这是Test Connection的信息。显然不是目标板没上电，因为把连接线全部清除后，出错信息也是这个。所以应该是接线出错

要接 TMS, TCK, RST, TVD, GND

VCC, GND, RST, +两线制JTAG（TMS, TCK），至少五根线