THS7314信号问题

如附件电路所示，使用EL5172将差分PAL信号转换为单端PAL信号，经由THS7314芯片环路输出两路PAL信号。
调试中发现，由TP24位置输入PAL信号，经THS7314环路输出两个PAL信号给ADV7401,显示正常。
由外部输入差分PAL信号，经EL5172转换为单端PAL信号，直接输出给ADV7401,显示正常。
但是，由外部输入差分PAL信号，经EL5172转换为单端PAL信号，再经THS7314环路输出给ADV7401,则不能正常显示，图像闪烁，有时采样不到同步信号。
按照电路中EL5172配置所示，CVBS=PAL+ - PAL-.
请问THS7314与EL5172搭配存在兼容问题么？ 如何解决。

EL5172 +-5V 供电，THS7314 3.3V 供电，要采用交流耦合，注意信号幅度，另外阻抗匹配也要加。

补充一下，
在EL5172与THS7314除了加AC couple，
根据EL5172的datasheet，a small series resistor at the output can help
to reduce peaking.As the load resistance
becomes lower, the output swing is reduced respectively.

EL5172的输出尝试+串联电阻以及减小load resistor.电阻值的选择要阻抗匹配成75ohm。另外PCB走线也要走成stip line,特征阻抗为75ohm

而且
The power supply pins should have a 0.1 μF to 0.01 μF capacitor placed as close as possible to these pins.
Failure to do so may result in the THS7314 outputs ringing or have an oscillation. Additionally, a large capacitor,
such as 22 μF to 100 μF, should be placed on the power supply line to minimize interference with 50/60 Hz line
frequencies.

对于EL5172也必须按下面要求做

 The power supply
pin must be well bypassed to reduce the risk of oscillation.
For normal single supply operation, where the VS- pin is
connected to the ground plane, a single 4.7µF tantalum
capacitor in parallel with a 0.1µF ceramic capacitor from VS+
to GND will suffice. This same capacitor combination should
be placed at each supply pin to ground if split supplies are to
be used. In this case, the VS- pin becomes the negative
supply rail.

THS7314芯片为单电源供电，不支持带负电源的CVBS信号，需要对信号做偏置处理，或者更换为正负电源供电的芯片。