微波EDA网,见证研发工程师的成长!
首页 > 研发问答 > 无线和射频 > GPS,北斗,GNSS设计交流 > MTK GPs

MTK GPs

时间:10-02 整理:3721RD 点击:
MEB-1280 User Manual1        Introduction
Mobinote MEB-1280 small form factor board is the newest generation of Mobintoe GPS module. The module is powered by MediaTek MT3318. Mobinote proprietary navigation technology that provides you with stable and accurate navigation data. The smallest form factor and miniature design is the best choice to be embedded in a device such as portable navigation device, personal locator, speed camera detector and vehicle locator.
1.1        Product Features
        32 parallel channels
        SMT type with stamp holes
        High quality stereo audio output
        TCXO design
        0.1 second reacquisition time
        NMEA-0183 compliant protocol/ customize protocol
        Enhanced algorithm for navigation stability
        Excellent sensitivity for urban canyon and foliage environments.
        DGPS (WAAS, EGNOS) support
        Auto recovery while RTC crashes
1.2        Product Applications
        Automotive navigation
        Personal positioning and navigation
        Marine navigation
        Timing application

1.3        Product Pictures
(1) MEB-1280

Figure 1 MEB-1280 Picture
(2) MEB-1280 Interface board




Figure 2 MEB-1280 Interface Board
1.4        The interface Board Pin Definition



Table 1 1 J2 Connector
Pin #        Signal Name        I/O        Description        Characteristics
1        ANTPWR        I        DC Supply Voltage Output        3.3V±5%
2        NC                       
3        VBAT        I        RTC Backup Battery
Supply         
4        VCC        I        DC Supply Voltage Output        3.3V±5%
5        nRESET        I        System reset
(Active low)         
6        NC                       
7        GPIO5/SCS0#        I/O        General purpose I/O         

8        GPIO6/SO        I/O        General purpose I/O         

9        GPIO7/SIN        I/O        General purpose I/O         

10        GPIO8/SCK        I/O        General purpose I/O         

11        TX0        O        Serial Port 0         
12        RX0        I        Serial Port 0         
13        GPIO3        I/O        General purpose I/O         

14        NC                       
15        NC                       
16        NC                       
17        NC                       
18        GND        G        Reference Ground       
19        PPS        O        One pulse per second       
20        GND        G        Reference Ground       
Table 1 2 Switch SW3
Pin #        Signal Name        0/1        Description        Characteristics
1        VCC_ANT_2V85                Bias voltage switch for Active Antenna        0: open. No voltage provide antenna.
1:Provide 2.85V to antenna.

?

?

发个MT3318芯片datasheet,谢谢!
邮箱:gpscity@126.com

什么东东

MTK的GPS怎么?
谁用过,评价一下啊

?什么东西啊?

Copyright © 2017-2020 微波EDA网 版权所有

网站地图

Top